RCmagvintage

Hello, This is the new introduction about one of RC200 which I have.
As you know, RC200 cares very much in an active vehicle about the selection of parts in the end of 70's.
Especially for the matching of Muff/Carb and plus one more something new for the charm point.
Here attached is a kind of realization for that after long working.
If it will be getting Ref, a little for your restoration, I am fine

Details are roughly as below.
*Motor: K&B McCOY modified
*Carb: OPS 8.0mm Inlet slide (the collaboration of K&B and OPS carb was popular at that time)
*Muff: Early article of McCOY Can Muff (Silver)
*Brake Arm: replace to White Nylon one (choice from Thorp production)
*Reinforcement of the servo
*Visible Air Filter
*Webra Fuel Filter

Enjoy


↓around power unit


ASSOCISTA

Very very nice luv these radio plate funky cuts, and all the other small nice bits Great works

Bonjour Simonsg, Many thanks always for your compliment
How is your RC300?
I can not wait to see your miracle working for it

ASSOCISTA

Bravo:!: Very beautiful rc200, I like all the rare details you put in to this car It will be an inspiration for my own rc200 restoration in the near future.

OCA1

Hi OCA1
I am quite happy that it will be good ref, for your next restoration
Here is one more shot. Pls enjoy



ASSOCISTA

Currently I fond that the front rim of MRP is very good matching to RC200.
The design has a similar holes as the RC200 original one.
Below is set up with that.Enjoy





ASSOCISTA

ASSOCISTA, the MRP wheel llooks good on your RC200, it has a similar design, but it looks that it has a larger diameter. Did you use a special adaptor to fit it, or does it have the same bearing/bushing size as the original RC200 wheel?

Cheers,
OCA1

OCA1, The diameter of MRP is larger exactly compared with RC200's.
It's the same diameter as the front rim of RC300.
As I make the shape of tire lower profile looking like 35/40, It looks larger
The special adapter is not necessary to use. Because the axle shaft is the same one and just insert it except the s/steel collar
MRP had the other version,which was ball bearing spec as well.



ASSOCISTA

ASSOCISTA, The MRP wheel is pretty cool looking, it looks like a larger diameter wheel and with low profile tires it looks super! Thank you for the nice rim comparison picture.

This is a ball bearing version of the RC300 wheel



OCA1

OCA1 a écrit :ASSOCISTA, The MRP wheel is pretty cool looking, it looks like a larger diameter wheel and with low profile tires it looks super! Thank you for the nice rim comparison picture.

This is a ball bearing version of the RC300 wheel



OCA1

Oh yes,This is more competition item ! Large bearing is a great durability

ASSOCISTA